Installation Notes - TR-Electronic MP-Series Benutzerhandbuch

Installation notes

10 Installation notes
PROFINET supports linear, tree or star structures. The bus or linear structure used in
the field buses is thus also available for Ethernet.
For transmission according to the 100Base-TX Fast Ethernet standard, network
cables and plug connectors in category STP CAT5 must be used (2 x 2 shielded
twisted pair copper wire cables). The cables are designed for bit rates of up to
100 Mbit/s. The transmission speed is automatically detected by the encoTRive and
does not have to be set by means of a switch.
Addressing by switch is also not necessary, this is done automatically using the
addressing options of the PROFINET-Controller.
The cable length between two subscribers may be max. 100 m.
To ensure safe and fault-free operation, the
-
-
-
-
In particular the EMC directive in its valid version must be observed!
 TR-Electronic GmbH 2008, All Rights Reserved
Page 216 of 252
PROFINET Design Guideline, Order-No.: 8.062
PROFINET Installation Guideline for Cabling and Assembly, Order-No.: 8.072
PROFINET Installation Guideline for Commissioning, Order-No.: 8.082
and the referenced Standards and PNO Documents contained in it must be
observed!
TR - EMO - BA - DGB - 0019 - 08
Printed in the Federal Republic of Germany
06/06/2019