Telegram Selection - TR-Electronic MP-Series Benutzerhandbuch

13.4 Telegram selection

For configuration of the process data the relevant modules must be inserted in the
slots provided. Which modules must be inserted depends on the process data
configuration defined in the encoTRive (see chapter 5.2).
In the following example it is assumed that the object directory in the encoTRive is in
default status and thus corresponds to the process data configuration as per standard
telegram 100 (see chapter 5.2).
In this case the module Enco Std. Telegramm 100 must be inserted in slot 1
(see Figure 34: Incorporating encoTRive into the network).
The automatically allocated input and output addresses can be retrospectively
changed if necessary via the General dialog. Here also the HW-identification is
indicated, which is used for the addressing and identification of the assembly.
At free PZD or free telegram configuration, i.e., if no standard telegram is selected,
at first the outputs and then the inputs must be put into places of insertion (slots)
first.
Printed in the Federal Republic of Germany
06/06/2019 TR - EMO - BA - DGB - 0019 - 08
 TR-Electronic GmbH 2008, All Rights Reserved
Page 233 of 252