Introduction To The Trigger System - PeakTech 1190 Bedienungsanleitung

11. Introduction to the Trigger System

Shown as Fig.10, there are a knob and four buttons in the "TRIGGER CONTROLS". The following practices
will direct you to be familiar with the setting of the trigger system gradually.
Press the "TRIG MENU" button and call out the trigger menu. With the operations of the 5 menu selection
1.
buttons, the trigger setting can be changed.
2. Use the "LEVEL" knob to change the trigger level setting.
With the rotation of the "LEVEL" knob, it can found that the trigger indicator in the screen will move up
and down with the rotation of the knob. With the movement of the trigger indicator, it can be observed that
the trigger level value displayed in the screen changes.
3. Press the button "SET TO 50%" to set the trigger level as the vertical midpoint values of the amplitude of
the trigger signal.
4. Press the "FORCE TRIG" button to force a trigger signal, which is mainly applied to the "Normal" and
"Single" trigger modes.
5. The "SET TO ZERO" button is used to reset the trigger horizontal position.
Fig. 10 Trigger Control Zone
-122-