PeakTech 1190 Bedienungsanleitung Seite 145

Edge menu list:
MENU SETTING
CH1
CH2
Source
EXT
EXT/5
Mode Edge
Rising
Slope
Falling
Auto
Trigger Normal
mode Single
AC
DC
HF
Coupling
LF
100ns ~
Holdoff
10s
Holdoff
Reset
Fig. 37 Edge trigger menu
INSTRUCTION
Select CH1 as the trigger source.
Select CH2 as the trigger source.
Ext-trigger
Ext-trigger divide to 5 and extend trigger level range.
Set vertical channel trigger type for edge trigger.
Trigger in signal rising edge
Trigger in signal falling edge
Acquire waveform whatever detect trigger condition or not
Only acquire waveform when match trigger condition
Only acquire waveform for single time when detect trigger condition then
stop
Not allow DC portion to pass.
Allow all portion pass.
Not allow high frequency of signal pass and only low frequency portion
pass.
Not allow low frequency of signal pass and only high frequency portion
pass
Turn "TRIG LEVEL" knob to set time slot before another trigger event.
Reset hold time to 100ns
-144-