Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety Precautions
This product complies with the requirements of the following European Community Directives: 2004/108/EC
(Electromagnetic Compatibility) and 2006/95/EC (Low Voltage) as amended by 2004/22/EC (CE-Marking).
Overvoltage category II; pollution degree 2.
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-circuits
(arcing), the following safety precautions must be observed.
Damages resulting from failure to observe these safety precautions are exempt from any legal claims
whatever.
*
Do not use this instrument for high-energy industrial installation measurement.
*
Do not place the equipment on damp or wet surfaces.
*
Do not exceed the maximum permissible input ratings (danger of serious injury and/or destruction of the
equipment).
*
The meter is designed to withstand the stated max voltages. If it is not possible to exclude without that
impulses, transients, disturbance or for other reasons, these voltages are exceeded a suitable presale
(10:1) must be used.
*
Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or fuse holding.
*
Disconnect test leads or probe from the measuring circuit before switching modes or functions.
*
Check test leads and probes for faulty insulation or bare wires before connection to the equipment.
*
To avoid electric shock, do not operate this product in wet or damp conditions.
*
Conduct measuring works only in dry clothing and rubber shoes, i. e. on isolating mats.
*
Never touch the tips of the test leads or probe.
*
Comply with the warning labels and other info on the equipment.
*
The measurement instrument is not to be to operated unattended.
*
Always start with the highest measuring range when measuring unknown values.
*
Do not subject the equipment to direct sunlight or extreme temperatures, humidity or dampness.
*
Do not subject the equipment to shocks or strong vibrations.
*
Do not operate the equipment near strong magnetic fields (motors, transformers etc.).
*
Keep hot soldering irons or guns away from the equipment.
*
Allow the equipment to stabilize at room temperature before taking up measurement
(important for exact measurements).
*
Do not input values over the maximum range of each measurement to avoid damages of the instrument.
*
Use caution when working with voltages above 35V DC or 25V AC. These Voltages pose shock hazard.
*
Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or solvents.
*
The meter is suitable for indoor use only
*
Do not operate the meter before the cabinet has been closed and screwed safely as terminal can carry
voltage.
*
Do not store the meter in a place of explosive, inflammable substances.
*
Do not modify the equipment in any way.
*
Do not place the equipment face-down on any table or work bench to prevent damaging the controls at
the front.
-111-
Werbung
Inhaltsverzeichnis
