How To Use Executive Buttons - PeakTech 1190 Bedienungsanleitung

Note:
1. Entering into Autoscale function and
2. At the mode of Autoscale, the oscilloscope can self-estimate "Trigger Type" (Edge, Video, and Alternate)
and "mode" (Edge, Video). If now, you press "Trigger mode" or "Type", the forbidden information will
display on the screen.
3. At the mode of XY and STOP status, pressing AUTO SET to enter into Autoscale, DSO switches to YT
mode and AUTO status.
4. At the mode of Autoscale, DSO is always in the state of DC coupling and AUTO triggering. In this case,
the forbidden information will be showing when making Triggering or Coupling settings.
5. At the mode of Autoscale, if adjust the vertical position, voltage division, trigger level or time scale of CH1
or CH2, the oscilloscope will turn off Autoscale function and if press AUTOSET again, the oscilloscope will
enter into Autoscale.
6. Turn off the submenu at the Autoscale menu, the Autoscale is off and turn on the submenu still enters into
the function.
7. When video triggering, the horizontal time scale is 50us. If one channel is showing edge signal, the other
channel is showing video one, the time scale refers to 50us as video one as standard.
8. While the Autoscale is working, below settings will be made forcibly:
* The unit will switch from non-main time base to main time base status.
* The unit will switch to Peak detection menu while in the state of Average sampling mode.

43. How to Use Executive Buttons

AUTOSET
This button is used for the automatic setting of all control values of the instrument to generate the waveform
suitable for observation. Press the AUTOSET button and the oscilloscope will perform the fast automatic
measurement of the signal.
The function items of AUTOSET are shown as the following table:
Function Items
Acquisition Mode
Vertical Coupling
Vertical Scale
Bandwidth
Horizontal Level
Horizontal Sale
Trigger Type
Trigger Source
Trigger Coupling
Trigger Slope
Trigger Level
Trigger Mode
Display Format
flicker will be on the top left corner. (flicker every 0.5 second)
Setting
Current
DC
Adjust to the proper division.
Full
Middle
Adjust to the proper division
Current
Show the minimum number of channels.
Current
Current
Mid-point Setting
Auto
YT
-173-