PeakTech 1190 Bedienungsanleitung Seite 150

28.2.4. Slope Trigger
Slope trigger sets the oscilloscope as the positive/negative slope trigger within the specified time.
The Slope Trigger Menu is shown as Fig. 43.
Slope Trigger menu list
MENU SETTING
CH1
Source
CH2
Mode Slope
When
Settings 24ns~10s
High level
Low level
Slew rate
Auto
Trigger
Normal
mode
Single
100ns
Holdoff
10s
Holdoff
Reset
Fig. 43 Slope Trigger menu
INSTRUCTION
Select CH1 as the trigger source.
Select CH2 as the trigger source.
Set slope condition
Turn "TRIG LEVEL "knob to set slope time
Turn "TRIG LEVEL "knob to set the High level
Turn "TRIG LEVEL "knob to set Low level
Slew rate=( High level- Low level)/ Settings
Acquire waveform whatever detect trigger condition or not
Only acquire waveform when match trigger condition
Only acquire waveform for single time when detect trigger condition then stop
～
Turn "TRIG LEVEL" knob to set time slot before another trigger event
Reset hold time to 100ns
-149-