PeakTech 1190 Bedienungsanleitung Seite 167

Delay 1→2 : The delay between the two channels at the rising edge.
Delay 1→2 : The delay between the two channels at the falling edge.
+Duty: +Duty Cycle, defined as +Width/Period.
-Duty: -Duty Cycle, defined as -Width/Period.
Press the F1 menu selection button to choose Source or Type menu. You can choose the channel to be
measured from the Source menu and choose the measurement Type (Freq, Period, Mean, PK–PK, and Cyc
RMS). The menu is displayed as Fig.64.
40. Measure
Four automatic measured values can be detected on each channel simultaneously. Only if the waveform
channel is in the ON state can the measurement be carried out. No automatic measurement can be made in
the following situation: 1) on the saved waveform. 2) on the mathematical waveform. 3) on the XY format. 4)
on the Scan format.
Measure the frequency, the peak-to-peak value of the Channel CH1 and the mean, the RMS of the Channel
CH2, following below steps:
1. Press the F1 menu selection button and choose Source.
2. Press the F2 menu selection button and choose CH1.
3. Press the F3 menu selection button and choose CH1.
4. Press the F4 menu selection button and choose CH2.
5. Press the F5 menu selection button and choose CH2.
6. Press the F1 menu selection button and choose Type.
7. Press the F2 menu selection button and choose Freq.
8. Press the F3 menu selection button and choose Pk-Pk.
9. Press the F4 menu selection button and choose Mean.
10. Press the F5 menu selection button and choose Cyc RMS.
Fig. 64 Measure Menu
-166-