1. Safety precautions
This product complies with the requirements of the following
directives of the European Union for CE conformity: 2014/30/EU
(electromagnetic
2011/65/EU (RoHS).
Overvoltage category III 600V; pollution degree 2.
CAT I:
For signal level, telecommunication, electronic with
small transient
CAT II:
For local level, appliances, main wall outlets, portable
equipment
CAT III: Supplied from a cable under earth; fixed installed
switches, automatic cut-off or main plugs
CAT IV: Units and installations, which are supplied overhead
lines, which
i.e. main-switches on current input, overvoltage-diverter, current
use counter.
To ensure safe operation of the equipment and eliminate the
danger of serious injury due to short-circuits (arcing), the following
safety precautions must be observed.
Damages resulting from failure to observe these safety
precautions are exempt from any legal claims whatever.
*
Do not use this instrument for high-energy industrial
installation
*
Do not place the equipment on damp or wet surfaces.
*
Do not exceed the maximum permissible input ratings of 600V
AC/DC and 10A (danger of serious injury and/or destruction of
the
equipment).
*
The meter is designed to withstand the stated max voltages. If
it is not
transients, disturbance or for
other reasons, these voltages are exceeded a suitable presale
(10:1)
compatibility),
over voltage
are stand in a risk of persuade of a lightning,
measurement.
possible to exclude without that impulses,
must be used.
31
2014/35/EU
(low
voltage),