GF NeoFlow Betriebsanleitung Seite 37

Instruction manual
3. Remove the valve piston (3). Check the o-ring (6) for wear or damage and replace, if required.
3
Assembly
1. Assembly is the reverse process. On reassembly, lightly lubricate all seals with a drinking-water safe lubricant such as Molyko-
te 111 or Klübersynth UH1 64-2403.
2. If a metal threaded insert (2) is detached from the main body (1), fully remove it and fasten it again.
1
2
CAUTION!
Lubricate seals and sliding components with an approved lubricant!
Correct lubrication of the seals and sliding components is required for the correct functioning of the valve. Other lubricants may at-
tack materials and seals and are not permissible.
► Lubricate seals only with a drinking-water safe lubricant such as Molykote 111 or Klübersynth UH1 64-2403.
6
2
NeoFlow pressure reducing valve
35