OMCN ROLL R6 Betriebsanleitung Seite 51

3.5 ROLL R6 M
Fig. 6: ROLL R6 M
Item Designation
1 TFT monitor
2 Control panel
3 Vernier caliper (electronic)
4 Wheel guard, moving
5 Pedal
6 Tray
7 On/off switch
8 Clamping tool holders
9 Mains socket
10 Connection for angular width gauge*
11 Quick-action clamping nut
12 Centering flange with tie rod
13 Centering cone
14 Manual vernier caliper
15 Balance weight pliers
16 Measuring compasses
17 Concave sleeve
18 Spacer ring
19 Rubber guard ring
20 Plastic spatula
21 USB port
* special accessories
OMCN spa
Function/purpose
Software display (measured values and operating instructions)
Operation of ROLL R6 M.
+ Recording of rim distance and rim diameter.
+ Determination of positions for attachment of adhesive weights.
+ Protection of operator against flying particles (e. g. dirt, water).
+ Starting and stopping measurement.
Blocking of wheel for attachment or removal of balance weights.
For storing balance weights and accessories.
Switching ROLL R6 M on and off
Storage of accessories
Connection for power cord.
Connect the angular width gauge to the machine.
Centering and attachment of wheel on cone
Wheel attachment.
Centering of wheel on flange shaft.
Can be used as substitute if the electronic vernier caliper is defective.
For attaching balance weights to rim and removing weights.
Can be used as substitute if the rim width and rim diameter cannot be recorded
electronically.
For use with quick-action clamping nut and for external attachment of centering
cone.
For use with quick-action clamping nut and aluminum rims..
For use with quick-action clamping nut and aluminum rims.
For removing adhesive weights
Software upgrade
User information | ROLL R6 M | 51
1 695 600 694
en
|
2016-09-28