Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring the DRAC/MC
This section includes general configuration information for the DRAC/MC module. For detailed
information on using the remote management features of the system, see the Dell Remote Access
Controller/Modular Chassis User's Guide.
Enabling and Configuring the DRAC/MC to Use a Serial or Telnet Console
The DRAC/MC supports a serial and Telnet interface for its command line interface (CLI) and has
the capability to switch this serial interface to any server module or switch module within a
chassis.The following subsections provide information about how to enable and configure a
serial/Telnet console on the DRAC/MC.
NOTE:
The connect server-x serial command requires that the server module's Serial Port setting under
the BIOS setup group Integrated Devices be set to DRAC/MC. When a Telnet session is established to the
DRAC/MC and the setting of this server module's serial port is not DRAC/MC, connect server-x yields a
blank screen.
NOTE:
By default, Telnet is in the OFF state on the DRAC/MC module. See "Enabling the Telnet Console"
to turn this port ON.
Configuring the System Setup Program on the Server Module
If required, the DRAC/MC provides the capability to redirect a server module's text console
through the serial port or Telnet interface. Perform the following steps to configure your System
Setup program to redirect text console from a server module to the DRAC/MC serial or Telnet
interface.
NOTE:
You must configure the System Setup Program in conjunction with the connect serial/telnet
command.
NOTE:
You must perform the following sequence of commands locally. Once you have completed these
steps, you can redirect the server console to the DRAC/MC remotely.
1 Turn on or restart your server module.
2 Press <F2> immediately after you see the following message:
<F2> = System Setup
3 Scroll down and select Console Redirection.
Downloaded from
www.Manualslib.com
manuals search engine
General System Configuration
11
Werbung
Kapitel
