Installing The System In The Rack - Dell POWERVAULT MD1120 Rack-Installationsanleitung

Installing the System in the Rack

To install the system on the rack, perform the following procedure:
1 From the front of the rack, position the system in front of the mounting
Figure 1-7. Installing the System in the Rack
1
2 Slide the system fully into the rack until the system front panel is touching
3 Tighten the captive thumbscrews on each side of the system's front panel
4 Attach the power cord and cables to the system and then connect
Downloaded from www.Manualslib.com
CAUTION:
If you are installing more than one system, install the first system
in the lowest available position in the rack.
CAUTION:
Because of the size and weight of the system, never attempt
to install the system in the mounting rails by yourself.
rails you installed in the rack cabinet.
1
mounting rails (2)
the vertical rails (see Figure 1-7).
(see Figure 1-7).
the system to the electrical outlet.
manuals search engine
2 thumbscrews (2)
Rack Installation Guide
2
17