Removing Blockages Of The Grinder; Cleaning The Water Tank - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

REMOVING BLOCKAGES OF THE GRINDER

Rarely, foreign objects merged with the coffee beans may block the grinder. Try the
following procedure to make the grinder work again.
CAUTION
– Do not poke in the openings of the grinder (intake or outlet).
You cannot remove the blockage this way! Do not leave the grinder switched on,
if the grinder is blocked! Always immediately switch off the grinder (pressing
the grinder button again), when the grinder does not work.
1. Try to turn the grind size dial to the highest number (11). However, do not use
violence! Press the grinder button for checking whether the grinder is working
again. Switch off the grinder immediately, if there is no reaction.
2. When the grinder does not work and/or you cannot turn the grind size dial,
repeatedly switch the grinder on and off in quick succession, but do not leave
the grinder switched on.
3. If there is still no respond, get in contact with your vendor for examination and
repair.

CLEANING THE WATER TANK

We recommend cleaning the water tank regularly for maintaining the good per-
formance of the appliance. Additionally, this will avoid surplus lime deposits in the
water system and the build-up of algae and germs in the water tank.
CAUTION
hinges of the lid and the valve at the bottom. Do not poke in the valve.
IMPORTANT - When removing the water tank from the machine, do not tilt the
water tank, and do not attempt to move it sidewise. Only move the water tank
vertically.
1. Ensure that the machine is unplugged.
2. Remove the water tank at the rear of the machine. For this, by the handle at the
rear, pull the water tank lid upwards. Then, by the water tank lid, pull the water
tank vertically upwards and out.
NOTE
If you find it difficulty to move the water tank up by the water tank lid, it may be
easier to hold the water tank at both sides for removing it. However, in any case,
do not tilt the water tank to avoid damage to the valves.
– Handle the water tank with care to avoid damage to the
EN
137