Texturing Milk - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

5. Remove the vessel from the steam wand.
6. In the case, you diluted an already prepared drink, wipe the steam wand, using
a wet, clean cloth or kitchen towel keeping in mind that the steam wand will
be very hot, thus ensuring that you do not touch the steam wand with your skin
(see: 'Care and Cleaning / Cleaning the Steam Wand').
7. Grasp the steam wand at the handle and turn the steam wand to the drip tray.
After diluting a drink, turn the selection dial clockwise for some seconds and
back to produce a short burst of hot water for flushing the steam wand.

TEXTURING MILK

WARNING
when the espresso machine is in their reach. During operation and shortly there-
after, the steam wand will be very hot and hot steam and hot water could escape
from the steam wand and group head. Do not hold your hands and arms near the
steam wand tip or under the group head. To avoid splashing of hot milk, before
removing the milk, always stop the steam flow by turning the selection dial to the
central standby position. After texturing, the steam wand will be very hot. Only
touch the steam wand at the handle to avoid scalding! When using glasses or
plastic mugs, DO NOT point the steam wand directly at the side walls of the
vessel, because even heat-resistant glass could crack and plastic could melt
due to the extreme local heating. It is better to avoid using glass or plastic vessels
for texturing.
NOTE
You cannot use the espresso function and steam function at the same time.
NOTE
When using a metal vessel for texturing (e.g. the provided milk jug), you can feel
the temperature of the milk at the bottom of the vessel. With porcelain vessels this
is impossible, because porcelain is a bad heat conductor.
Various useful tips for texturing milk are given in section 'Tips for Best Results / Tips
for Texturing Milk'.
1. Prepare the appliance for operation (see: 'Preparing the Appliance for Opera-
tion'). Hold a clean, moist cloth at hand. Wait for the appliance to reach ope-
ration temperature and all buttons illuminate. Ensure that the water tank is filled
with a sufficient amount of water (between the MIN and MAX filling lines). Turn
the steam wand to the drip tray.
– Risk of Burns! Young Children must always be supervised,
EN
117