Important Safeguards For Electrical Appliances - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

on or in the appliance or any of its parts (e.g. water tank, warming
plate, or cup tray), to avoid damage. For operation, only fill cold,
clear tap water or low-mineral, non-carbonated bottled water in the
water tank. Always ensure that the filling level is between the MIN
and MAX filling lines (at least 250ml, up to 2.5 litres). To avoid
damage to the pump, do not operate the appliance with the water
tank missing or not filled sufficiently.
• Do not fill any other substances but ground coffee or coffee pads into
the filter baskets to avoid damage to the appliance. To avoid dama-
ge to the grinder: Do not fill pre-ground coffee powder into the bean
hopper. Only fill fresh, dry, whole coffee beans into the bean hop-
per. Do not let any liquids get into the bean hopper. Always keep the
bean hopper completely dry.
• Always switch OFF the appliance via the power button (all buttons
are dark), then unplug, and leave the appliance cool down, before
cleaning the appliance, or when the appliance is not in use. Additi-
onally, empty the drip tray and water tank, before moving the appli-
ance. Always hold the machine at both sides at the upper part of the
back post for moving the appliance. Do not hold the appliance at
the group head, water tank, drip tray, steam wand, bean hopper,
or power cord for moving the appliance.
• Keep the appliance and its parts and accessories clean. Clean the
appliance according to the instructions in chapter 'Care and Clea-
ning'. Do not use any abrasive cleaners, cleaning pads (e.g. metal
scouring pads), or any corrosive cleaners (e.g. disinfectants, chemical
bleach, unsuited descaling solutions) for cleaning. Ensure to descale
the appliance in time to avoid damage due to excessive build-up of
lime.
• Do not place the espresso machine in an automatic dishwasher.

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

Place the appliance near a suitable wall power outlet to connect the
appliance directly to a protected mains power supply with protective con-
ductor (earth/ground) connected properly. Ensure that the voltage rating
EN
88