Gastroback Design Espresso Advanced Barista Bedienungsanleitung Seite 87

heating, mechanical or electric shock), or if there are any perceptible
damages or leakages, or if the appliance is not working properly. If
one of these cases occurs during operation, immediately unplug the
appliance. Get in contact with an authorized service centre for exa-
mination and/or repair.
• Operate the appliance on a well accessible, stable, level, dry, and
suitable large table or counter that is resistant against heat and water.
Always keep the appliance and the table or counter clean and dry,
and wipe off spilled liquids immediately. Do not place the appliance
on the edge of the table or counter.
• Do not place the appliance or any part of it on or near hot surfaces
(e.g. burner, heater, or oven). Do not use the appliance or any parts
or accessories of the appliance with any other device or for any other
purpose than described in this booklet.
• During operation keep the appliance in an appropriate distance of at
least 30cm on each side to any sensitive or delicate objects, to avo-
id damage due to heat and moisture. Ensure free access to the water
tank, the operating elements of the appliance and to the power outlet
used.
• This appliance can be used by persons with reduced physical, senso-
ry or mental capabilities or lack of experience and knowledge, inclu-
ding children aged from 8 years on, if they have been given supervi-
sion or instruction concerning the use of the appliance in a safe way
and understand and handle with the hazards involved. Even care
and cleaning shall not be performed by children without supervision.
Young children must always be supervised to ensure that they do
not play with the appliance or any parts of the appliance or the
packaging.
• Before operating the appliance, always ensure that the appliance is
assembled completely and correctly according to the instructions in
this booklet. Do not use violence to avoid damage.
• Do not place any clothes or tissues or similar materials on or under
the appliance during operation, to avoid overheating, fire and electric
shock. Do not place any heavy and/or sharp-edged foreign objects
EN
87