Adjusting The Amount; Adjusting The Extraction Volume - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

ADJUSTING THE AMOUNT

16. The first time you use the appliance, we recommend using the factory settings
(approx. 7g for a single espresso and approx. 14g for a double shot). If you
are not satisfied with the result, you can change the amount. The single dosage
can be adapted as well as the double dosage (via pressing the grinding button
twice consecutively; see below).
NOTE
If you wish to simply get twice the dosage, that is programmed for a single shot,
you may simply start the grinder twice with the single dosage.
17. Programming the single dosage: Hold the grinding button pressed, while
the grinder shall operate. Release the grinding button, as soon as the desired
amount is reached. When releasing the grinding button, the appliance stores
the given off amount in memory.
IMPORTANT - After pressing the grinding button, the grinder starts with a short
delay. If you wish to use the double dosage, you must press the grinding button
twice within this short delay. For setting up the double dosage, the second time
you need to hold the grinding button pressed, until the desired amount is given off.
19. Programming the double dosage: press the grinding button shortly and imme-
diately thereafter, hold the grinding button pressed, until the desired amount is
reached. When releasing the grinding button, the given off amount is stored in
memory.

ADJUSTING THE EXTRACTION VOLUME

The first time you use the appliance, we recommend using the factory setting of the
extraction volume (espresso amount; approx. 30ml for a single shot and approx.
66ml for a double shoti). If you are not satisfied with the result, you can change the
extraction volume.
IMPORTANT - You need to install the portafilter and at least a double-wall fil-
ter basket at the group head, for programming the desired amount of espresso.
However, it is better, to program the extraction volume with the same procedure
you prefer for a usual shot.
For programming an espresso button (1 cup or 2 cups):
1. Install the portafilter with the filter basket at the group head.
2. Hold the espresso button pressed, until the desired amount is reached.
EN
121