Gastroback Design Espresso Advanced Barista Bedienungsanleitung Seite 131

Problem
The coffee is too cold.
After extraction, water is
still in the filter basket.
Using the Grinder
The appliance is switched
on, but the grinder does
not work.
Too much/too little coffee
powder is given off
and/or
the grinder stops unex-
pectedly and/or
the usual dose is not
given off.
Possible Reasons
The water tank is not
inserted correctly.
You did not pre-heat the
cups.
You did not pre-heat the
portafilter.
Making cappuccino or
latte: The milk is not hot
enough.
This may be normal.
The appliance is still pre-
heating.
The grinder is blocked by
a foreign object.
The grind size has been
changed.
The grind amount setting
is incorrect.
The Easy Solution
Push the water tank down at the back of the appliance
until the water tank lid is level with the top of the appli-
ance (see: 'Operation / Filling the Water Tank').
Rinse your cups and mugs via the hot water function, and
place them onto the warming plate, before starting an
extraction (see: 'Operation / Pre-Heating').
Pre-heat the portafilter and filter basket via the hot water
function (see: 'Operation / Pre-Heating').
Use a metal milk jug for texturing milk. During texturing,
hold your hand on the milk jug to feel the temperature
(see: 'Operation / Texturing Milk').
No need to worry.
Wait until all buttons illuminate continuously. Then try
again.
Immediately switch off the grinder (pressing the grinder
button).
Follow the instructions, described in 'Care and Cleaning /
Emptying and Cleaning the Bean Hopper'.
When changing the grind size, it may be required to
change the amount setting. Adjust the appropriate setting
(see: 'Changing the Default Settings / Setting Up the
Grinder').
Adjust the grinder (see: 'Changing the Default Settings /
Setting Up the Grinder').
EN
131