Gastroback Design Espresso Advanced Barista Bedienungsanleitung Seite 118

2. Fill approx. 100ml of fresh, cold milk (sufficient for normal cappuccino) into a
sufficiently large, high vessel made of porcelain or metal. Prefer the milk jug of
the appliance.
IMPORTANT - During texturing, the milk may reach up to three times of its volu-
me, causing overflow when using a vessel that is too small. Prefer the provided
milk jug.
WARNING
hot water and hot steam are pressed out of the steam wand and the steam wand
gets very hot.
3. Turn the selection dial counter-clockwise (to the steam icon) and let the appliance
operate until the water is flushed out of the steam wand and only steam is given
off. The hot water/steam indicator flashes. Turn the selection dial back to the
central standby position for stopping the steam flow.
NOTE
Pressing the water out may last a few seconds.
4. Wait 2-3 seconds. Then turn the steam function on again for some seconds for
heating the steam wand up to steam temperature. Switch off the steam function.
5. By the handle, turn the steam wand to a position, where you can hold the milk
vessel conveniently under the steam wand. Lift the milk vessel to immerse the tip
of the steam wand at an angle below the surface of the milk. The steam wand
should be near the side wall of the milk vessel.
IMPORTANT - If required, stop texturing in time to avoid overflow. The milk and
milk jug will be heated up via the steam. Be careful, while touching the milk jug
during texturing.
6. To start frothing, turn the selection dial to the steam icon again. With the steam
wand in correct position, a vortex is generated in the milk.
7. When using a metal vessel: hold your hand at the bottom of the
milk vessel for feeling the temperature, which must get lukewarm.
When using a porcelain vessel: let the steam function operate for 5-10
seconds. Then, carefully lower the vessel to bring the tip of the steam wand near
the surface of the milk. Steam and air build up the froth. When using a metal
vessel, let the appliance operate, until the vessel just gets too hot for touching
it. Otherwise, let the appliance operate for another 5-10 seconds. While doing
so, ensure that the milk does not overflow.
EN
118
– When the steam function is activated via the selection dial,