Recalling The Factory Settings; Solving Problems - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

3. As soon as the espresso button is released, the appliance memorizes the
amount, given off up to this point.

RECALLING THE FACTORY SETTINGS

The appliance keeps the factory settings in memory, no matter, whether you have
changed various individual pre-programmed settings. This may be useful, when your
way for getting the optimum settings missed its aim and you wish to start again right
from the beginning.
IMPORTANT - When resetting the appliance to the factory settings, any individu-
ally programmed settings are overwritten irreversibly.
IMPORTANT - The following reset procedure does not affect the grind size, which
can only be changed via the grind size dial. The recommended setting is 3.
Hold the power button pressed until the signal sounds (approx. 4-5 seconds). There-
after, the appliance is using the factory settings again.

SOLVING PROBLEMS

If any problems occur during operation, you will find the solution in this chapter.
Problem
Emergency stop required?
After switching on, water
runs out of the group
head.
The appliance does not
reach the operating tem-
perature. The power but-
ton flashes in unusual high
frequency.
There is still a gap bet-
ween the portafilter and
filter basket.
EN
122
Possible Reasons
The water system is flus-
hed.
The selection dial is turned
to the hot water function
or steam function.
An obstacle in the por-
tafilter.
The filter basket is not
inserted correctly.
The Easy Solution
Unplug the appliance.
This is normal operation. No need to worry.
Turn the selection dial to the central standby position.
Then, wait until all buttons illuminate.
Do not use violence! Remove the filter basket and
check, whether there is any obstacle in the portafilter.
Only use 1 of the provided filter baskets.
Gently press the filter basket down into the portafilter to
make it engage within the portafilter with a click.