Frothing Milk; Removing The Attachment - Gastroback 42606 DESIGN ESPRESSO PLUS Bedienungsanleitung

1. Remove the portafilter from the grouphead. Grasp the portafilter by the black
handle and rotate the portafilter to the left (clockwise) until
the lock is released.
2. Empty the portafilter over a bowl or sink. Dispose of the
used espresso powder in the household waste or compo-
stable kitchen waste. Do not dispose of the espresso pow-
der in the sink, otherwise the drain could be clogged.
3. The filters sit firmly in the portafilter. Lift the filter by the recesses on the sides of
the portafilter to remove it from the portafilter.
4. Rinse the filter and portafilter with clear water and allow
these components to dry.

FROTHING MILK

WARNING:
time. Always check first that these components have cooled down before you touch
these.
This espresso machine is equipped with a swiveling steam wand and a black attach-
ment for frothing milk. This allows you to quickly and easily pro-
duce milk foam. If you need only a little milk foam, than remove
the attachment and use only the steam wand for frothing the milk.

Removing the Attachment

Make sure first, that this part has cooled down. Then pull the
attachment gently downward from the steam wand. Rotate the
attachment during process slightly back and forth.
Replacing the Attachment
Insert the attachment with the narrow end onto the steam wand
and push upwards to the top until it clicks into place. The attach-
ment should not wobble or fall off. Rotate the attachment during
the process might slightly back and forth.
Note:
The attachment has two resistors inside and is placed properly, when you have
pushed the attachment for snapping up over the first resistance onto the steam
wand. The steam wand should be located only in the narrow part of the attach-
ment and must not protrude from the top down.
54
The steam wand and the attachment are very hot after use for some
Steam
wand
Attach-
ment