Setting Up The Grinder; Selecting The Grind Size - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

NOTE
The espresso machine comes with useful factory settings already programmed. For
your first tries, you should use these settings. Adapt the settings, when getting expe-
rienced and your individual likings are not met via the steps suggested in chapter
'Tips for Best Results'.
IMPORTANT - When programming new settings for the ground amount and/
or the extraction volume, any other settings are overwritten without a warning.
However, if required, you can restore the factory settings (see: 'Recalling the Fac-
tory Settings').

SETTING UP THE GRINDER

You can select the grind size and the amount of coffee powder given off. The
amounts for a single shot or a double shot can be programmed separately.

SELECTING THE GRIND SIZE

The grind size will affect the water flow rate through the coffee in the filter basket
and the flavour of the espresso. When setting the grind size, it should be fine but
not too fine or powdery (see: 'Tips for best Results / The Grind').
There are 11 possible settings given on the grind size dial at the right side of the
group head.
NOTE
The smaller the number, the finer the grind size. The larger the number, the coar-
ser the grind size. We recommend to start with the grind size 3 and to adjust the
setting as required, after checking the results. The grinder should run during setting.
13. Push the portafilter (including the appropriate filter basket) into the grinder cradle
below the grinder outlet. Alternatively, you may place a small bowl under the
grinder outlet. This is useful for collecting the given off coffee powder and che-
cking the result.
14. Press the grinding button. The grinder starts operation audibly. With coffee
beans in the bean hopper, ground coffee powder is given off.
15. To adjust the grind size: with the grinder still running, rotate the grind size dial
to the back of the machine for getting a finer grind size. Turning to the front,
results in a coarser coffee powder.
EN
120