IMPORTANT - While performing the following procedure, ensure that the filling
level in the water tank does not drop below the MIN filling line. Additionally, ensu-
re to empty the bowl in time and replace it under the group head and steam wand.
5. Press the 2 espressi button for pumping hot water through the group head. Leave
the machine operate until the hot water flow stops automatically.
6. Turn the selection dial counter-clockwise to the steam icon for pumping steam
through the steam wand. After approx. 10 seconds, turn the selection dial back
to the vertical standby position for stopping the steam flow. If required, empty
the bowl and replace it under the group head and steam wand.
IMPORTANT - When pressing an espresso button immediately after producing
steam, the water system may still be too hot for brewing espresso. In this case, the
espresso button flashes without water coming out. You need to wait some seconds
until the water flows. The delay is required for cooling the water system to the cor-
rect espresso temperature.
7. Monitoring the filling level in the water tank, repeat the last 2 steps (3 and 4)
at least 10 times. If required, intermediately fill the water tank with cold water
again.
8. After flushing the water system, the appliance is ready for operation.
OPERATION
WARNING
espresso machine in in their reach. Always wipe off spilled liquids immediately.
Only use vessels made of heat-resistant materials (e.g. china, metal) for ope-
ration! Due to the extreme local heating when texturing milk, even heat-resi-
stant glass could crack and plastic could melt, resulting in splinters, particles and
harmful chemicals getting into your beverages. Additionally, hot liquid could run
out, causing injuries and damage.
For various useful tips concerning the use of the machine, please refer to 'Tips for
Best Results'. An overview of the properties of your new espresso machine is given
in chapter 'Properties of Your New Espresso Machine').
EN
106
– Do not leave young children without supervision, if the