Gastroback Design Espresso Advanced Barista Bedienungsanleitung Seite 134

Problem
The milk has a stale taste. The milk is not fresh and/
No hot water
or
the water drips only spa-
rely out.
Error Messages of the Appliance
All button flash.
The power button flashes
with unusually high fre-
quency.
The descaling indicator illu-
minates.
EN
134
Possible Reasons
or not cold enough.
The steam wand is not
clean.
The water in the water
tank is stale.
The steam wand is
clogged.
The water tank is empty
or not installed correctly.
The water tank is empty
or not installed correctly.
During pre-heating, the
selection dial is turned to
the hot water function or
steam function.
Descaling is required.
The Easy Solution
Use refrigerated and really fresh milk for texturing (see:
'Operation / Texturing Milk').
Clean the steam wand thoroughly (see: 'Care and Clea-
ning / Cleaning the Steam Wand').
Empty and clean the water tank and fill the water tank
with cold fresh water at least every day (see: 'Care and
Cleaning / Cleaning the Water Tank'). Only use fresh tap
water. Let some water run out, before filling the water
tank.
Leave the steam wand cool down and clean the steam
wand thoroughly (see: 'Care and Cleaning / Cleaning the
Steam Wand').
Ensure that the water tank is filled sufficiently before ope-
ration (between MIN and MAX filling line). Ensure that
the water tank is installed correctly (see: 'Operation /
Filling the Water Tank').
Fill a sufficient amount of clear tap water into the water
tank (between MIN and MAX filling line). Ensure that the
water tank is installed correctly (see: 'Operation / Filling
the Water Tank').
Before operation, always ensure that the
water tank is filled with a sufficient amount
of water (between MIN and MAX filling line). Do not
operate the appliance with the water tank
empty.
Turn the selection dial at the left side of the group head
to the central standby position.
Perform a descaling cycle (see: 'Care and Cleaning /
Descaling the Appliance').