Inserting The Water Filter - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

CAUTION
the appliance. The pump of the water system could get damaged, when operated
without water. For removing the water tank, the water tank must be pulled straight
upwards. Do not attempt to tilt the water tank or move the water tank sidewise to
avoid damage. Do not use any abrasive cleaners, cleaning pads (e.g. metal scou-
ring pads), or any corrosive cleaners (e.g. disinfectants, chemical bleach) for clea-
ning. Do not use any hard or sharp-edged objects for cleaning the appliance.
Do not place the appliance in an automatic dishwasher.
3. Clean all removable parts (water tank, portafilter, filter baskets, drip tray, bean
hopper lid) and the accessories in warm dishwater (see: 'Care and Cleaning').
4. After cleaning, place the appliance on an appropriate working place near a
suitable wall power outlet (see: 'General Safety Instructions').
5. Ensure that the drip tray is empty and installed correctly (see: 'Operation / Emp-
tying the Drip Tray'). Thereafter, insert the water filter (see: 'Inserting the Water
Filter').

INSERTING THE WATER FILTER

You should operate the appliance with the water filter correctly assembled and in
place in the water tank. This will protect the water system of the appliance from par-
ticles (e.g. lime) or excessive lime deposits.
NOTE
On normal use, the filter cartridge lasts about two months. If the coffee machine is
left unused with the water filter installed, the filter cartridge will last max. 3 weeks,
because the filter material gets dry and inactive.
1. Remove the filter cartridge from the packaging and turn the indicator disc to the
next 2 months.
2. Activate the filter cartridge by pouring tap water into the hole in the filter
cartridge until water comes out of the opening at the side. This way, flush the
filter cartridge for more than 1 minute.
3. Remove the water tank from the rear of the machine. If required, pull the used
water filter out. Fill the water tank with an appropriate amount of water that will
be sufficient for immersing the filter cartridge completely in the water.
4. Completely immerse the filter cartridge in the water tank and for approx. 10
seconds turn the filter cartridge within the water in all directions, sloping it and
pressing it slightly to enable the air bubbles to escape.
EN
104
– Please, do not forget to fill the water tank, before switching on