Redmond RMK-M911E Betriebsanleitung Seite 9

Manually adjusting the cooking time, consider time adjustment range and interval of selected programme, given in the table
of default settings.
For your convenience the cooking time range in all programmes starts with the minimum setting, enabling you to prolong the
operating time of the programme, if the dish is undercooked.
In certain automatic programmes countdown starts only when the device reaches its operating temperature. E.g. If you set the
"STEAM" programme of 5 minutes, the countdown of the programme begins only when the water comes to a full boil providing
enough steam. In the "PASTA" programme, the countdown begins after water starts boiling and the "Start" button is being re-
pressed.
MASTERFRY function A5
The REDMOND RMK-M911E multikitchen is equipped with a raisable heating element. It allows you to use both the bowl
and the frying pan in the multikitchen (included in set).
Be sure to use a thermal glove for gripping the tongs. Do not touch the heating disc regardless of the position it's in!
For safety reasons use tongs when changing the position of the heating element (included in set).
To fix the heating element into the upper position carefully lift it until tight and slightly turn counterclockwise until secure
fixation of the mounts in the slots on the walls of the working chamber.
To place the disc heating element into the lower position slightly lift it, so that its mounts exit slots on the walls of the
working chamber, and, having turned the disc clockwise, carefully lower it.
DO NOT try to change the position of the heating element if the appliance is plugged in!
DO NOT close the lid if the disc heating element is set to an upper position.
For cooking in the multikitchen use only frying pan, included in set.
Time Delay Function
This function allows setting the programme to finish by certain time. Cooking time may be delayed for a period from 10
minutes to 24 hours in 10-minute intervals. Setting the Time Delay function, take the cooking time of the programme into
consideration. The time of a delay should be longer than the cooking time of the selected programme; otherwise the programme
starts running right after you press "Start".
When the automatic programme is selected and the temperature and cooking time are adjusted, you may set the "Time Delay".
1. Press the "Time Delay" button to enter the Time Delay setting mode. The words Time Delay are displayed. The timer is
blinking.
2. Press the "Hour" button repeatedly to adjust the hours in 24-hour format. Hold the button down to scroll through the
digits.
3. Press the "Min" button repeatedly to adjust the minutes. Hold the button down to scroll through the digits.
4. If you need to set a delay shorter than 1 hour, repeatedly press the "Hour" button to reset time to zero and adjust the
minutes using the "Min" button.
5. To cancel the settings press the "Reheat/Cancel" button and reset.
6. When the time is set press and hold down the "Start" button. The Time Delay function indicator lights up. Set programme
starts running and the countdown begins.
7. Your meal will be ready when the time set expires. When the programme fini shes, the device automatically switches to
"Keep Warm" (the "Reheat/Cancel" button indicator lights up).
8. Press the "Reheat/Cancel" button to cancel the "Keep Warm". The button indicator goes off.
The Time Delay function is available in all automatic programmes except "FRY", "PASTA" and "QUICK COOK".
It is not recommended to use the Time Delay function if dairy and other perishable products are being used (eggs, fresh milk,
meat, cheese etc.).
Setting the "Time Delay" in the "STEAM" programme remember that the countdown starts only when the device reaches its
operating temperature (water comes to a full boil).
Keep Warm Function
The function is activated at the end of a cooking programme. When the programme finishes, the temperature of the meal
(70-75°C) is being maintained for a period of time up to 24 hours. The "Reheat/Cancel" button indicator lights up and the
"Keep Warm" count up is being displayed. Press and hold down the "Reheat/Cancel" button to disable the function.
Disabling The "Keep Warm" In Advance
Automatic activation of the Keep Warm function at the end of the programme may sometimes be undesirable. REDMOND
RMK-M911E allows you to deactivate the function in advance, while setting the programme or during its operation. Press and
hold down the "Menu / Keep Warm" button to disable the function. The "Reheat/Cancel" button indicator goes off. To reactivate
the function, repress and hold down the "Menu / Keep Warm" button (the "Reheat/Cancel" button indicator goes off).
Reheat Function
REDMOND RMK-M911E can be used for warming up cold meals. To reheat cold meals:
• Put the products into the bowl. Place the bowl inside the device.
• Close the lid until it clicks into place and plug in the unit.
• Press and hold down the "Reheat/Cancel" button for a few seconds until an audible signal is heared. Corresponding indi-
cators light up and the "reheating" process begins. The timer starts its countdown.
The meal will be warmed up to 70-75°C and the temperature will be maintained for the next 24 hours. To cancel the function
press and hold down the "Reheat/Cancel" button. Corresponding indicators go off.
The function may operate for a period of 24 hours, however, we recommend using it moderately, because a prolonged thermal
exposure may sometimes affect flavour characteristics of the meal.
Standard Operating Procedure for Automatic Programmes
1. Measure the ingredients according to the recipe.
2. Put them into the bowl. Make sure that all the ingredients including liquid are below the scale mark indicating maximum
capacity. Place the bowl inside the device. The bowl and the heating element must fit tightly.
3. Close the lid until it clicks into place. Plug in the unit.
4. Repeatedly press the "Menu / Keep Warm" button to select the programme (corresponding indicator lights up).
5. Use the "Hour" and "Min" buttons to adjust the time set by default for each programme.
6. Set Time Delay function if needed. Time Delay function is not available in the "FRY", "PASTA" and "QUICK COOK" programmes.
7. Press and hold down the "Start" button. The "Start" and "Reheat/Cancel" button indicators light up. Set programme starts
running and the countdown begins. Countdown of the "STEAM" programme begins only when water comes to a full boil,
providing enough steam. In "PASTA" after water comes to a full boil, products are added and the "Start" button is being
repressed.
8. Press and hold down the "Menu / Keep Warm" button to disable the Keep Warm function in advance if needed (the
"Reheat/Cancel" button indicator goes off). Repress the "Menu / Keep Warm" button to reactivate the function. The Keep
Warm function is not available in the "YOGURT/DOUGH" and "BREAD" programmes.
9. When cooking time expires, the device makes an audible sound. Depending on your settings the unit either switches to
"Keep Warm" (the "Reheat/Cancel" button indicator lights up) or enters standby mode (the "Start" button indicator blinks).
10. To interrupt cooking process at any stage, to cancel the set programme or the Keep Warm function press and hold down
the "Reheat/Cancel" button.
To achieve better cooking results, we recommend to refer to the cookbook provided. Each out of recipes has been adjusted for
this particular model.
If you did not achieve the desired result using automatic programmes, try versatile programme called "MULTICOOK", featuring
a wide time and temperature adjustment range. This programme gives endless opportunities for new culinary experiments.
"MULTICOOK" Programme
This programme can be used to cook any meal with your personal time and temperature settings. REDMOND RMK-M911E,
featuring the "MULTICOOK" programme will be able to replace a big number of kitchen appliances. Now any recipe, either
from your family cookbook or Internet, can be adjusted for your multikitchen.
For your convenience, the device does not switch to "Keep Warm" automatically by the end of the programme if the cooking
temperature is less than 80°C. It may be manually reactivated by pressing and holding down the "Menu / Keep Warm" button
right after the programme starts running. The "Reheat/Cancel" button indicator lights up.
• Programme's default temperature is 100°C, default time is 15 minutes.
• Temperature adjustment range (use "Temperature" button to adjust) is from 35°C to 170°C in 5°C intervals.
• Cooking time adjustment range is from 5 minutes to 12 hours with the following intervals: less than 1 hour 1 minute,
over an hour 5 minutes.
A big number of various dishes can be prepared with the help of "MULTICOOK". Follow the recommendations of our chefs given
in the recipe book and the table of recommended temperature settings.
GBR
RMK-M911E
9