How It Works; Safety Instructions - LaserLiner CableTracer Pro Bedienungsanleitung

Read the operating instructions and the enclosed brochure „Guarantee and additional notices"
!
completely. Follow the instructions they contain. Safely keep these documents for future reference.
Function / Application
Universal, exible cable tracer set including sender and receiver.
– Non-contact tracing of the transmission signal by the receiver.
– Locates electrical cables, fuses, circuit breakers, metal pipes (such as heating pipes) and much more.
– Locates interrupted cables in existing installations and short-circuits in existing installation cables.
– May be used with or without mains voltage, up to max. 400V.
– Display of DC and AC voltages up to max. 400V.
– Single-pole search, for optimal cable and object search in greater depths.
– Two-pole search, for locating fuses, short-circuits and ground fault circuit interrupters.
– High transmission frequency of 125 KHz allows for exact and fail-safe locating performance without
power failures.
– Signal coding allows as many as 7 senders to be used with one receiver and is thus ideal for complex
installation settings.
– Integrated AC voltage detector recognises and locates live lines.
– Permanent AC voltage warnings increase safety with sender and receiver.
– Automatic and manual modes for adjustment to the particular measuring conditions.
– Integrated illumination of measuring points, powerful LED lighting.
– Overvoltage category CAT III (according to EN 61010-1, max. 300V) and all lower categories. The
devices and accessories must not be used in overvoltage category CAT IV (e.g. low voltage installation
sources).

How it works

Measurement is performed using one or more senders and one receiver. The sender feeds coded signals
into the cable to be checked. The signal is a modulated current creating an electromagnetic eld around
the conductor. The receiver recognises this eld, decodes it and is then able to nd and locate cables with
this signal.

Safety instructions

– The device must only be used in accordance with its intended purpose and within the scope of the
speci cations.
– Only the original measuring leads may be used. Their voltage, category and ampere rated powers must
match those of the measuring device.
– Isolate the device from all current sources before opening the battery compartment cover.If possible, do
not work alone.
– Hold the device by the grip sections only. Do not touch the test prods during measurement.
– If you are working with voltages higher than 25 V AC/60 V DC, exercise extreme caution. Touching the
electrical conductors at such voltages poses a risk of life-threatening electric shocks.
16 GB