Output Submenu - Cosmo Multi 3 Montage- Und Bedienungsanleitung

3. OPERATION AND FUNCTION
Relay option PWM/0-10 V option
Yes Yes
Yes No
Yes No
Yes No
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
*If the relay option and / or speed control is deactivated, the adjustment in the adapter option will have no effect.
With the menu item Funct., an optional function already saved can be temporarily deactivat-
ed or re-activated respectively. In this case, all adjustments will remain stored, the allocated
outputs will remain occupied and cannot be allocated to another function. The allocated sensor
will be monitored for faults.
By selecting Switch, the function can be activated or deactivated respectively by means of an
external potential-free switch.
If Switch is selected, the channel Sensor appears, in which a sensor input can be defined as
a switch.
3.6

OUTPUT SUBMENU

The Output submenu is available in almost all optional functions. Therefore, it will not be ex-
plained in the individual function descriptions.
In this submenu, relays and / or signal outputs can be allocated to the function selected. All
adjustments required for the outputs can be made in this menu.
All controller and module (if connected) outputs available will be displayed. If - is selected,
the function will run normally in the software but will not operate an output. Relay and signal
outputs can be activated separately. Depending on the adjustments made, the following results
are possible:
Adjustments
Speed control Adapter option
Yes Yes
Yes No
Yes Yes
No irrelevant*
Yes No
Yes Yes
No irrelevant*
Yes irrelevant*
No irrelevant*
Adjustment
Description
channel
Relay Relay option
Relay Relay selection
PWM/0-10 V PWM/0-10 V option
Output Signal output selection
Signal Signal type
Profile Curve
Speed Speed control
Min. Minimum speed
Max. Maximum speed
Adapter Adapter option
Inverted Inverted switching
option
Blocking Blocking protection
protect. option
Manual mode Operating mode
Behaviour of the relay Behaviour of the signal
output output
Î
On/Off Modulating
Î
Burst control -
Î
On/Off -
Î
On/Off -
Î
On/Off Modulating
Î
On/Off Modulating
Î
On/Off 0 % / 100 %
Î
- Modulating
Î
- 0 % / 100 %
Adjustment range / selection Factory setting
Yes, No
system dependent
Yes, No
system dependent
PWM, 0-10 V
Solar, Heating
Yes, No
20 ... 100 %
20 ... 100 %
Yes, No
Yes, No
Yes, No
Max., Auto, Min., Off
109
Result
Behaviour of the
adapter
Modulating
Modulating
Modulating
0 % / 100 %
0 % / 100 %
Modulating
0 % / 100 %
-
-
No
system dependent
No
system dependent
PWM
Solar
system dependent
30 %
100 %
No
No
No
Auto