Power Subsystem; Power-On Checks; Power-On Troubleshooting Overview - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

Table 2-7 Troubleshooting flowchart (continued)
4 Open the Reports menu and print the
configuration pages to verify that all the
Information
accessories are installed.
pages
Are all the accessories installed?
Yes
5 Does the print quality meet the customer's
requirements?
Image quality
Yes
6
Can the customer print successfully from the
host computer?
Interface
Yes. This is the end of
the troubleshooting
process.

Power subsystem

Power-on checks

The basic product functions should start up when the product is connected into an electrical outlet and
the power switch is pushed to the on position. If the product does not start, use the information in this
section to isolate and solve the problem.

Power-on troubleshooting overview

Turn on the product power. If the control panel display remains blank, random patterns display, or
asterisks remain on the control panel display, perform power-on checks to find the cause of the
problem.
During normal operation, the main cooling fan begins to spin briefly after the product power is turned
on. Place your hand over the holes in the left-side cover, near the formatter. If the fan is operating, you
will feel air passing out of the product. You can also lean close to the product and hear the fan
operating. You can also place your hand over the hole in the right-rear lower corner. If the fan is
operating, you should feel air being drawn into the product. When this fan is operational, the DC side
of the power supply is functioning correctly.
After the fan is operating, the main motor turns on (unless the right or front cover is open, a jam
condition is sensed, or the paper-path sensors are damaged). You might be able to visually and
audibly determine if the main motor is turned on.
If the fan and main motor are operating correctly, the next troubleshooting step is to isolate print
engine, formatter, and control panel problems. Perform an engine test. If the formatter is damaged, it
might interfere with the engine test. If the engine-test page does not print, try removing the formatter
ENWW
If accessories that are installed are not listed on the configuration
page, remove the accessory and reinstall it.
After evaluating the configuration pages, see step 5.
No
Compare the images with the sample defects in the image defect
tables. See the images defects table in the product service manual.
No
After the print quality is acceptable, see step 6.
Verify that all I/O cables are connected correctly and that a valid
IP address is listed on the Jetdirect configuration page.
No
If error messages display on the control panel when you try to print
an event log, see the control panel message section of the service
manual.
When the customer can print from the host computer, this is the
end of the troubleshooting process.
Troubleshooting process
99