Manual sensor tests
Performs tests to determine whether the paper-path sensors are operating correctly.
1.
At the product control panel, press the Home
2.
Open the following menus:
Administration
●
Troubleshooting
●
Diagnostic Tests
●
Manual Sensor Test
●
Table 2-10
Manual sensor tests
Sensor or switch
name
Cartridge-door switch
Left door switch
Right door sensor
Cartridge install sensor
Top sensor
Fuser loop sensor
Fuser output sensor
Duplex refeed sensor
108
Chapter 2 Solve problems
Sensor
Replacement part
number
number
SW3
CN
SW1
CN
SR8
CN
SR1
CN
SR9
CN
SR6
CN
SR12
CN
SR2
CN
button.
Description
Paper-path sensor
test name
Toner cartridge door
SW3 Cartridge Door
switch
Left door open switch
SW1 Left Door
Right door open
SR8 Right door
sensor
Toner cartridge
SR1 Cartridge install
installed sensor
sensor
Top sensor PCA
Sr9 Top Sensor
Fuser loop sensor
SR6 Fuser loop 1
sensor
Fuser output sensor
SR12 Fuser output
sensor
Duplexer refeed sensor
SR2 Duplexer refeed
Testing of sensor
Open the cartridge
door.
Open the left door.
Open the right door.
Open the cartridge
door, and then remove
the toner cartridge.
Open the cartridge
door, remove the toner
cartridge, raise the
registration shutter,
and then use a small
flat-blade screwdriver
to activate the sensor.
Open the cartridge
door, remove the toner
cartridge, and then
press the sensor lever.
Open the left door,
pull down the fuser
shutter, and then use a
screwdriver to activate
the sensor.
Remove the duplexer,
insert a sheet of paper
so that it covers the
refeed sensor, and
then reinstall the
duplexer.
ENWW