Duplex Switchback Sensor (Sr1); Figure 2-7 Duplex Switchback Sensor - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

Duplex switchback sensor (SR1)

1.
Remove the duplexer from the product.
2. Insert a sheet of paper in the duplexer until the sheet covers the sensor.
Figure 2-7
3.
Reinstall the duplexer, and then check the control-panel display for sensor response.
4.
If there is no response, replace the duplexer.
ENWW
Duplex switchback sensor
Tools for troubleshooting
117