Usb Storage Device (Control-Panel Menu) - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

USB storage device (control-panel menu)

1.
Copy the xxxxxxx.bdl file to a portable USB flash drive.
2.
Turn the product on, and then wait until it reaches the Ready state.
3.
At the product control panel, press the Home
4. Open the Device Maintenance menu.
5. Select the USB Firmware Upgrade item, and then press the
6.
Insert the portable USB storage device with the xxxxxxx.bdl file on it into the USB port on the
front of the product, and then press the
7.
Select the xxxxxxx.bdl file, and then press the
TIP:
select the correct file for this product.
8. When the product prompts you to confirm the upgrade, press the
When the upgrade is complete, the product will initialize.
NOTE:
9. When the upgrade process is complete, print a configuration page and verify that the upgrade
firmware version was installed.
302 Chapter 2 Solve problems
If there is more than one xxxxxxx.bdl file on the storage device, make sure that you
The upgrade process can take up to 10 minutes to complete.
button.
OK button.
OK button.
OK button.
OK button.
ENWW