HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung Seite 248

2: Normal, typed (not AutoSense)
●
3: Light paper 1, 2, or 3, typed or AutoSense
●
4: Heavy paper 1, typed or AutoSense
●
5: Heavy paper 2, typed or AutoSense
●
6: Heavy paper 3, typed or AutoSense
●
7: Glossy paper 1, typed or AutoSense
●
8: Glossy paper 2, typed or AutoSense
●
9: Glossy paper 3, typed or AutoSense
●
A: Glossy film, typed or AutoSense
●
B: Transparency, typed or AutoSense
●
C: Label
●
D: Envelope1, Envelope2, or Envelope3
●
E: Rough (designated paper 1), typed or AutoSense
●
F: Reserved for future fuser mode
●
Y = previous product sleep state
◦
Z = next product sleep state
◦
0: Printing
●
1: Standby level 1 (no temperature control)
●
2: Standby level 2 (high temperature control)
●
3: Standby level 3 (middle temperature control)
●
4: Standby level 4 (low temperature control)
●
5: Middle sleep
●
6: Deep sleep
●
F: Off
●
Recommended action
W = A: High fuser temperature 2
1. Remove and then reseat the fuser. Make sure there is no residual paper in the fuser. Make sure the
product is not located in front of a vent or window where cool air may interfere with the ability of
the fuser to heat up.
2.
Check the product power source. Make sure the power source meets product requirements. Make
sure this is the only device using the circuit.
222 Chapter 2 Solve problems ENWW