Execute A 2 Format Disk - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

CAUTION:
and the solution in the product service manual recommends this solution. After executing the 2 Format
Disk function, the product is unusable.
HP recommends backing-up product configuration data before executing a 2 Format Disk if you
need to retain customer-defined settings. See the Backup/Restore item in the Device
Maintenance menu.
Reasons for performing a format disk
The product continually boots up in an error state.
●
NOTE:
The product will not respond to commands from the control panel.
●
Executing the 2 Format Disk function is helpful for troubleshooting hard disk problems.
●
To reset the product by deleting all solutions and customer-defined settings.
●

Execute a 2 Format Disk

1. Turn the product on.
2. Touch the HP logo that displays in the center of the touchscreen until the Preboot menu opens.
Press the
Preboot menu opens.
3.
Use the down arrow
button.
4.
Use the down arrow
button.
5.
Press the
NOTE:
firmware.
298 Chapter 2 Solve problems
HP recommends that you do not use the 2 Format Disk option unless an error occurs
Try clearing the error prior to executing a 2 Format Disk.
Stop button when the Ready, Data, and Attention LEDs are illuminated solid until the
button to highlight the 3 Administrator item, and then press the
button to highlight the 2 Format Disk item, and then press the
OK button again.
When the 2 Format Disk operation is complete, you will need to reload the product
OK
OK
ENWW