Rip Workstation Characteristics; Networking; Printing Supplies; Electrical Configuration - HP DESIGNJET L26500-Serie Handbuch Zur Vorbereitung Des Aufstellungsorts

RIP workstation characteristics

The RIP computer and RIP software must be provided by the customer. Each RIP has specific
requirements. Check with your RIP vendor to find out the requirements for the PC that you'll be using for
the RIP station. Make sure that the RIP station is fully functional and ready for installation.

Networking

You are responsible for all networking requirements, and you must complete the following tasks:
NOTE:
In order to perform remote support, the printer must have access to the Internet using the LAN
connection.
Have a Gigabit Ethernet network ready for the day of installation.
●
Provide a CAT-6 LAN cable to connect the printer to your LAN and RIP workstation.
●
Provide a Gigabit Ethernet switch.
●

Printing supplies

The following supplies should be purchased in addition to the printer and should be available on the
day of installation:
Six HP 792 ink cartridges, one for each color: black, cyan, magenta, yellow, light cyan and light
●
magenta.
At least one roll of substrate to perform calibrations and printhead alignment during printer setup.
●

Electrical configuration

NOTE: An electrician is required for the setup and configuration of the building electrical system used
to power the printer and also for printer installation. Make sure that your electrician is appropriately
certified according to local regulations and supplied with all the information regarding the electrical
configuration.
Your printer requires the following electrical components to be supplied and installed by the customer,
according to the Electrical Code requirements of the local jurisdiction of the country where the
equipment is installed.

Single phase power

Table 2-3 Single phase line specifications
Number of power cords
Input voltage
Input frequency
Maximum total power consumption for
both power cords
4 Chapter 2 Site preparation requirements
Outside Japan
2
220-240 V~ (-10%+6%)
50 / 60 Hz
4.8 kW
Japan only
2
200 V (-10%+10%)
50 / 60 Hz
4.8 kW
ENWW