Execute A 3 Partial Clean; Format Disk - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

Executing the 3 Partial Clean function is helpful for troubleshooting hard disk problems.
●
To reset the product by deleting all solutions and customer-defined settings.
●
The product default settings are not properly working.
●

Execute a 3 Partial Clean

1. Turn the product on.
2. Press the
Preboot menu opens.
Touch the HP logo that displays in the center of the touchscreen until the Preboot menu opens.
3.
Use the down arrow
button.
4. Use the down arrow
button.
5.
Press the
6. Select the 1 Continue item, and then press the
NOTE:

Format Disk

The 2 Format Disk option erases the entire disk drive.
CAUTION:
Characteristics of a format disk
Customer-defined settings, third-party solutions, firmware files, and the operating system are
●
deleted.
NOTE:
Rebooting the product restores the firmware files from the Repository location, but does not restore
●
any customer-defined settings.
After executing the 2 Format Disk function, the message 99.09.67 displays on the control
●
panel.
After executing the 2 Format Disk function, the product firmware must be reloaded.
●
ENWW
Stop button when the Ready, Data, and Attention LEDs are illuminated solid until the
button to highlight the 3 Administrator item, and then press the
button to highlight the 3 Partial Clean item, and then press the
OK button again.
The product initializes.
After executing a 2 Format Disk option, the product is not bootable.
Rebooting the product does not restore the firmware files.
OK button.
Service mode functions
OK
OK
297