Faq - Klimagel CAPRI 109 Bedienungsanleitungen

PROBLEM
8.7.

FAQ

PUMP DOES NOT FISH
PRODUCT
CYLINDER IS ICED
PRODUCT LEAKS FROM THE
DISPENSER UNIT
PRODUCT LEAKS FROM THE
LATERAL TRAY
FOAM FORMATION IN TANK
THE COMPRESSOR STARTS
AND STOPS AFTER A FEW
SECONDS
MU0000_0717
POSSIBLE CAUSES
IF THE MACHINE IS TRI-PHASE AND THE PUMP ROD
TURNS CLOCKWISE
THE GASKETS ARE WORN
THE GEARS ARE BLOCKED
THE ROD DOES NOT TURN
PUMP DOES NOT FISH PRODUCT
THE BASE FOR ICE CREAM HAS LITTLE SUGARS AND
LITTLE FATS
THE KNOBS ARE NOT CORRECTLY TIGHTEN
THE PISTON GASKET IS RUINED
STUFFING BOX IS NOT MOUNTED OR RUINED
INCORRECT INSTALLATION OF THE COMPONENTS
WITHIN THE TANK
IF THE MACHINE HAS A WATER COOLING SYSTEM AND
THE WATER DOES NOT CIRCULATE
IF THE MACHINE IS AIR COOLED THE CONDENSATION IS
TOO HIGH
96
SOLUTION
INVERT THE TWO PHASES (BROWN
COLOR WIRES)
REPLACE GASKETS
TAKE OUT THE GEARS AND WASH THE
PUMP
CONTACT TECHNICAL ASSISTANCE
CHECK THAT THE PUMP FUNCTIONS
CORRECTLY
MODIFY MACHINE CONSISTENCY
PARAMETERS
TIGHTEN THE KNOBS BY HAND BY USING
A CLOTH.
SUBSTITUTE THE GASKET
MOUNT THE STUFFING BOX AND CHECK
PERIODICALLY THE STATE OF WORN
TIGHTEN THE WHITE KNOBS ON THE
BOTTOM OF TANK AND CHECK THAT THE
SOFT FLOW TUBE IS CONNECTED TO THE
PUMP AND IN PLACE.
OPEN THE INLET WATER FAUCET AND
CHECK IF THE TUBE IS CRUSHED OR
FOLDED
VERIFY THAT THE AREA OF ASPIRATION
AROUND THE MACHINE IS FREE AND
SUFFICIENT.
KLIMAGEL