Machine With Pump; Machine In Gravity - Klimagel CAPRI 109 Bedienungsanleitungen

4.4.

MACHINE WITH PUMP

The pump allows, by changing the position of the lever, to vary the proportion between the air
and the mixture it sends into the freezing cylinders; therefore, within certain limits, it is possible
to adjust the increase in volume more appropriate to the type of mixture used.
Place the lever in the center position.
If after extracting a certain number of cones, the ice cream is too heavy and wet, move the
lever of a notch at a time to the right. If, however, the ice-cream is mixed with the bubbles, turn
the lever a notch at a time to the left.
4.5.

MACHINE IN GRAVITY

Instructions for maintaining and obtaining good machine operation over time.
1. Always keep the mix level in the tank high (at least over half). The mixture in the tank is
stored at a temperature of + 4 ° C, both in production and in storage.
2. During the day, periodically mix the mixture in the tank with a palette to avoid separation
from itself, especially after long periods of stoppage in conservation, avoiding thickening along
the walls of the tank (unnecessary operation for machines with emulsifier in the tank).
3. Always use a fluid mixture with no lumps. A very dense mix with large lumps could block
the supply preventing the loading of the cylinder mix.
4. Keep the lower supply hole in position so that it will allow a good drop of the mixture from
the tank to the cylinder. By turning the internal regulator and by looking at the visual indicator,
you can adjust the percentage of air inside the cylinder.
5. The mix level in the tank must never exceed the visual indicator.
MU0000_0717
MIX LEVEL
MIX ENTRANCE
69
AIR ENTRANCE
VISUAL INDICATOR
KLIMAGEL