Installation; Connecting To The Electric Supply; Waste Electrical And Electronic Equipment Connection; General Switch - Klimagel CAPRI 109 Bedienungsanleitungen

3.

INSTALLATION

3.1.

CONNECTING TO THE ELECTRIC SUPPLY

3.1.1. CONNECTION
Before connecting the machine to the mains, make sure that the power supply voltage
corresponds to that shown on the identification plate.
Make sure to interpose between the machine and the mains a magneto thermic differential of
proper dimension to the required absorption power and with at least 3 mm contact openings.
The machine comes with power cord and plug relative to the machine model.

3.1.2. GENERAL SWITCH

After inserting the plug into the socket, turn on the main switch on the back of the machine
with the switch in the 'off' position on the command panel.

3.1.3. ROTATION SENSE INVERSION

If the direction of rotation of motors for three-phase machines is different from the rotation
arrow on the engine (for gravity machine) or the spindle rotates clockwise (for a pump
machine)
Switch the position of the gray wire with the brown wire of the plug.
For more information visit www.klimagel.it video section phase reversal
MU0000_0717 64 KLIMAGEL