Starting The Machine; Starting The Machine With Pump Version; Starting The Machine With Gravity - Klimagel CAPRI 109 Bedienungsanleitungen

4.8.

STARTING THE MACHINE

After installing the machine in accordance with the instructions in the INSTALLATION chapter
and after thoroughly washing and sanitizing the machine proceed as follows:

4.8.1 Starting the machine with pump version

Screw the tank fitting on the bottom of the tank with inside the flow tube and insert the pump
unit within the post, without connecting the flow tube.
Tank and cylinder loading
• Take a mixture pack from the chiller at a temperature of 4-5 ° C
• Pour the mixture contents into the tank, the mix level should not reach the pump.
• Activate '' CLEANING CYCLE ''
_________________________________________________________________________
If the pump DOES NOT fish the liquid mixture, check that the lid is closed firmly and if
the pump continues NOT to fish, wet with a spatula the gears inside.
• When the pump starts to fish select
select '' CLEANING CYCLE ''
• Open the dispenser lever for less than half and let the air mixed with product out to
minimize ice cream formation with air bubbles inside.
• Close the dispenser lever and select soft
after a few minutes the ice cream is ready.
_______________________________________________________________________
If a more homogeneous delivery of the product is desired from the dispenser, it is
advisable to pour about two liters of mix directly into the cylinder through the tank
fitting without the flow tube and then connect the flow tube to the tank fitting and
_____________________________________________________________________

4.8.2 Starting the machine with gravity

Remove the gravity piston from the bottom of the tank and immerse it in a sanitizing solution.
Tank and cylinder loading
Take a mixture pack from the chiller at a temperature of 4-5 ° C
•
Pour the mixture content into the tank, the mix level should not reach the gravity piston
•
visual indicator.
Activate '' CLEANING CYCLE"
•
Open the dispenser lever for less than half and let the air mixed with product out to
•
minimize ice cream formation with air bubbles inside.
Close the dispenser lever and select soft
•
needed, after a few minutes the ice cream is ready.
MU0000_0717
and check the pump draft
IMPORTANT
and connect the flow tube and
by filling the cylinder with mixture.
IMPORTANT
continue with the standard procedure
73
or production hard as needed,
or production hard as
KLIMAGEL