Klimagel CAPRI 109 Bedienungsanleitungen Seite 75

To change the consistency parameters, you must access the machine directly on the PLC
control panel
For more information, see the PARAMETER SETTING video at www.klimagel.it
To change the consistency parameters, perform the following steps on the PLC:
1.Press the button ESC
2.Press the button ARROW DOWN until selecting the function STOP.
3.Press the button OK and select YES, Press the button OK
4.Press the button ARROW UP until selecting the function PARAMETER.
5.Press the button OK Press the button ARROW RIGHT until selecting
the parameter of consistency desired.
6.Press the button ARROW DOWN until selecting the first digit variable G (i.e. 03,90)
7.Press the button ARROW RIGH until selecting the first digit variable G that you want
to modify (i.e. 3.90)
8.Press the button SEL
9.Press the button ARROW DOWN if you want to decrease or the button ARROW UP
se if you want to increment the value.
10.Press the button OK to save and press the button ESC
11.Press the button ARROW DOWN until selecting the function RUN
12.Press the button OK and select YES and Press the button OK
13.Press the button ESC
IMPORTANT
Do not set the consistency parameter beyond the maximum value
_________________________________________________________________________
MU0000_0717 75 KLIMAGEL