Troubleshooting; Possible Cause; Approved Set Of Blade And Saw Chain - Scheppach Csp560S Originalbetriebsanleitung

14. Troubleshooting

Problem
The engine does not start, or
it starts but does not continue
to run
The engine starts, but it does
not run at full power
Engine splutters
No power under load
Engine runs erratically
Excessive smoke
No power under load
Engine dies
Insufficient saw chain
lubrication (The guide rail and
saw chain become hot)

15. Approved set of blade and saw chain

Saw chain 325.058-76BL (7910100723)
Guide rail BE20-76-5812P (7910100724)
Saw chain
Guide rail
52 | GB

Possible cause

Incorrect starting procedure
Incorrectly adjusted
carburettor mixture.
Sooty spark plug
Clogged fuel filter
Contaminated air filter
Incorrectly adjusted
carburettor mixture
Incorrectly adjusted
carburettor mixture
Incorrectly set spark plug
Incorrectly adjusted
carburettor mixture
Incorrect fuel mixture
Saw chain blunt or loose
Fuel tank empty or fuel filter
incorrectly positioned in the
fuel tank
Saw chain oil tank empty
Oil passages clogged
Oregon 21BPX078X
Oregon 208PXBK095
www.scheppach.com
Correction
Observe the instructions given in this manual
Have the carburettor adjusted by the authorised
service centre
Clean/adjust or replace the spark plug
Replace the fuel filter
Remove the air filter, clean it and reinsert it
Have the carburettor adjusted by the authorised
service centre
Have the carburettor adjusted by the authorised
service centre
Clean/adjust or replace the spark plug
Have the carburettor adjusted by the authorised
service centre
Use the correct fuel mixture (ratio 40:1)
Sharpen the saw chain or insert a new saw chain –
tension the saw chain
Fill fuel tank
Fill the fuel tank completely or position the fuel filter
in the fuel tank accordingly
Fill up the chain saw oil tank
Clean the maintenance opening in the guide rail
Clean the groove of the guide rail