Troubleshooting - Scheppach BCHS300-ProS Original Bedienungsanleitung

18. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Device does not work
Device works intermittently
Dry the saw chain
Chain / guide rail hot
Chainsaw plucks, vibrates or
does not saw properly
Possible cause
Battery empty
Rechargeable battery not inserted correctly
External loose contact
Internal loose contact
On/off switch defective
No oil in the tank
Ventilation in the oil tank plug clogged
Oil outflow channel clogged
No oil in the tank
Ventilation in the oil tank plug clogged
Oil outflow channel clogged
Chain blunt
Chain too tight
Chain tension too slack
Chain blunt
Chain worn
Saw teeth point in the wrong direction
www.scheppach.com
Remedy
Charge battery
Remove rechargeable
battery and reinsert
Contact a specialist
workshop
Top up oil
Clean oil tank plug
Unclog oil outflow channel
Top up oil
Clean oil tank plug
Unclog oil outflow channel
Sharpen or replace chain
Check chain tension
Adjust chain tension
Sharpen or replace chain
Replace chain
Remount saw chain with
teeth pointing the correct
direction
GB | 45