Scheppach CSE 2200 Originalbetriebsanleitung Seite 44

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause
No power
Engine does not run
Chain brake
Carbon brushes worn
Chain does not move Chain brake
Chain blunt
Inadequate cutting Chain tension incorrect
performance Chain does not lie
correctly in the guide
Sawing difficult
Chain jumps off the Chain tension
blade
Saw chain runs hot Chain lubrication
44 | GB
Remedy
Checking the power supply socket, cable and plug
Cable damaged: Must be repaired by a specialist company.
Makeshift repairs (insulating tape, etc.) are strictly prohibited
Switch damaged: Must be repaired by a specialist company
See section "Chain brake" and "Release chain brake"
Have carbon brushes changed by a specialist company
Check chain brake, and release if necessary
Sharpen the chain
Tension the chain correctly
Attach the chain correctly
Tension the chain correctly
Check the oil level and top up if necessary
Check lubrication of the chain
www.scheppach.com