Introduction; Device Description; Scope Of Delivery; Proper Use - Scheppach Csp560S Originalbetriebsanleitung

1. Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no li-
ability for damage to the device or caused by the de-
vice arising from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Improper use.
Note:
Read the whole text of the operating manual before
assembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intend-
ed purpose.
The operating manual includes important instruc-
tions for safe, proper and economic operation of the
device, for avoiding danger, for minimising repair
costs and downtimes, and for increasing the reliabili-
ty and extending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must
be read and carefully observed by all operating per-
sonnel before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in these operat-
ing instructions and the separate regulations of your
country, the generally recognised technical rules re-
lating to the operation of woodworking machines
must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description

1. Saw chain
2. Guide rail
36 | GB
3. Front hand guard / chain brake
4. Front handle
5. Air filter housing cover
6. Air filter housing cover fixing nuts
7. Choke
8. Throttle interlock
9. Rear handle
10. Throttle
11. On/off switch
12. Fuel tank cover
13. Reverse starter handle
14. Cover for the oil-tank opening
15. Guide rail cover
16. Round saw chain file
17. Chain drive housing cover
18. Chain catcher
19. Claw stop
20. Spark plug wrench
21. Fuel mixing container
22. Screwdriver
23. Allen key, 4 mm
24. Primer button for cold start

3. Scope of delivery

• Chainsaw (1x)
• Saw chain (1x)
• Guide rail (1x)
• Guide rail base (1x)
• Spark plug wrench (1x)
• Allen key, 4 mm (1x)
• Fuel mixing container (1x)
• Round saw chain file (1x)
• Screwdriver (1x)
• Original Operating Manual (1x)
Open the packaging and carefully remove the device.
Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
Check whether the scope of delivery is complete.
Check the device and accessory parts for transport
damage.
If possible, keep the packaging until the expiry of the
warranty period.
m ATTENTION!
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!

4. Proper use

The device is non-intended to be used exclusively for
sawing wood. Trees may only be felled with the appro-
priate training. The manufacturer is not liable for dam-
age caused by non-intended use or incorrect opera-
tion.
www.scheppach.com