Storage; Transport; Disposal And Recycling; Troubleshooting - Scheppach Pcs38 Originalbetriebsanleitung

11. Storage

m CAUTION
Never store a chainsaw for longer than 30 days with-
out carrying out the following steps.
If you store your chainsaw temporarily for longer
than 30 days, it must be prepared ahead of time.
Otherwise, the remaining fuel in the carburettor will
evaporate and leave a rubbery sediment behind. This
can make it difficult to start and result in expensive
repair work.
1. Remove the tank cover slowly to release any
pressure in the tank. Carefully empty the tank.
2. Start the engine and let it run until it stops in order
to remove all fuel from the carburettor.
3. Allow the engine to cool down (approx. 5 minutes).
4. Remove the spark plug. You require the supplied
spark plug screwdriver combination tool for this.
5. Add one teaspoon of clean 2-stroke engine oil to
the combustion chamber.
6. Pull the starter cord slowly several times to coat
the internal components with oil. Re-insert the
spark plug.
Restarting the saw
1. Remove the spark plug.
2. Pull the starter cord quickly to remove excess oil
from the combustion chamber.
3. Clean the spark plug and check that the electrode
gap on the spark plug is correct is correctly set, or
insert a new spark plug with the correct electrode
gap.
4. Prepare the saw for operation.
5. Fill the fuel tank with the correct fuel-oil mixture.
6. Top up the chain oil in the chain oil tank.

12. Transport

To transport the chain, empty the fuel tank. Remove
coarse dirt from the saw with a brush or a hand brush.

13. Disposal and recycling

Notes for packaging
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and
the engine oil tank must be emptied!
54 | GB
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.

14. Troubleshooting

The table below contains a list of fault symptoms and
explains what you can do to rectify the problem if your
saw does not work properly. If the problem persists
after working through this list, please contact your
nearest service workshop.
m IMPORTANT!
Note regarding sending the saw in to a service centre:
For safety reasons, ensure that the saw does not
contain any residues of oil and petrol when sending
it back!
Service information
Please note that the following components of this
product are subject to normal or natural wear and
tear, and the following components therefore also
required to be used as consumables.
Wearing parts*: Saw chain, bar, saw chain oil, engine
oil, tine plate, chain catcher, spark plug, air filter, fuel
filter, saw chain oil filter
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from
our Service Centre. To do this, scan the QR code on
the front page.
Approved set of blade and saw chain
Saw chain
Guide rail
Saw chain
Guide rail
www.scheppach.com
3/8LP-53 (7910300706)
AP14-53-507P (7910300703)
Oregon 91P053X
Oregon 140SDEA041