Troubleshooting; Possible Cause - Scheppach CSE2500 Original Bedienungsanleitung

14. Troubleshooting

Fault

Possible cause

Motor does not run No electricity
Chain brake
Running out of carbon brush
Chain does not move Chain brake
Poor cutting perfor- Blunt chain
mance Chain tension
Check that the chain is fitted correctly
Saw works only with Chain tension
difficulty Chain jumps
off sword
Chain becomes hot Chain lubrication
36 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Check socket, cable and plug .
Damaged cable: Have repaired by Customer Ser-
vice. It is prohibited to patch the cable with insulating
tape . Damaged switches have to be replaced by a
Customer Service workshop
See section "chain brake" and "Releasing the chain
brake"
Change the carbon brush, ask a Customer Service
workshop
Check the chain brake, release if necessary.
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check the chain tension
Check oil level
Check Chain lubrication