Storage; Transport; Disposal And Recycling - Scheppach Csp560S Originalbetriebsanleitung

Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Saw chain, guide rail, chain oil, en-
gine oil, claw stop, chain catcher, spark plug, air filter,
fuel filter, chain oil filter
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from
our Service Centre. To do this, scan the QR code on
the front page.

11. Storage

m CAUTION
Never store a chainsaw for longer than 30 days with-
out carrying out the following steps.
Follow the cleaning and maintenance information be-
fore storing the unit!
Stowing the chainsaw
If you store a chainsaw for longer than 30 days, it
must be prepared ahead of time. Otherwise, the re-
maining fuel in the carburettor will evaporate and
leave a rubbery sediment behind. This could make
it difficult to start and result in expensive repair work.
• Slowly remove the fuel tank cap to release any
pressure in the tank. Carefully empty the fuel tank.
• Start the engine and let it run until the chainsaw
stops in order to remove the fuel from the carbu-
rettor.
• Allow the engine to cool down (approx. 5 minutes).
• Remove the spark plug.
• Add 1 teaspoon of clean 2-stroke oil to the com-
bustion chamber. Pull the reverse starter handle
slowly several times to coat the internal compo-
nents. Re-insert the spark plug.
m NOTE
Store the chainsaw in a dry location and far away
from potential sources of ignition, such as furnaces,
hot water boilers with gas, gas dryers, etc.
Recommissioning the chainsaw
• Remove the spark plug.
• Pull the reverse starter handle quickly to remove
excess oil from the combustion chamber.
• Clean the spark plug and check that the electrode
gap on the spark plug is correct is correctly set,
or insert a new spark plug with the correct elec-
trode gap.
• Prepare the chainsaw for operation.
• Fill the fuel tank with the correct fuel/oil mixture.

12. Transport

To transport the chain, empty the fuel tank. Remove
coarse dirt from the saw with a brush or a hand brush.

13. Disposal and recycling

Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and
the engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
www.scheppach.com
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
GB | 51