Sensors - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
3.6

SENSORS

The wheel aligner sensors do not need to be connected to any cables or wires for the measurement of angles.
The detector assemblies consist of infrared data transmitters/receivers and CCD-type transducers with an infrared emitter focal point.
All characteristic angles on both vehicle axles are monitored using 6 or 8 CCD sensors and infrared transmission.
Data transmission between infrared sensors is effective even in poor lighting conditions.
Data from the rear sensors are transmitted/received via infrared transmission to the front sensors. Data is transmitted by the front
sensors via Bluetooth-compatible modules.
Power is supplied by long-lasting 6V rechargeable batteries. The front and rear sensors are recharged using the sensor battery
charging cradles on the enclosure.
ATTENTION
• The rechargeable batteries are contained in a plastic housing. If there are any signs of corrosion, swelling
of the container or damage to the container, the battery must be removed immediately and replaced with
a new, undamaged, original one.
• The batteries must be handled with care. The user must wear protective gloves.
• Do not open or tamper with the battery pack and its shell.
• Use only the supplied battery pack.
• A label with notes and warning symbols is affixed to each battery
WARNING
• Do not cause short circuits and do not disassemble the battery pack.
• Do not expose the battery pack to excessive heat sources
The power and consumption data of the measuring heads with rechargeable battery are as follows:
Power supply
Average operation with battery in full efficiency and charged
Average charging time
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
NiMH battery (Nickel-Metal Hydride) 6V- 2Ah
Approximately 8 hours
Approximately 12 hours
2015-M362-0 EN-13